Starter is sold.
No idea on the wheel - how do you check visually? Quick search doesn't turn up anything for depth differences.
Starter is sold.
No idea on the wheel - how do you check visually? Quick search doesn't turn up anything for depth differences.
If youre willing to separate the spacer let me know
OR
if you can post a pic of it and maybe some measurements, it'd help me out greatly!!!!
I was at the EBR auction too, didnt buy the wheels because there are no street tires for that size!
But I want to do a chain conversion and any parts that are already ready to go would help me a lot
i sold off all the extra chain convwrsion parts. the new rear buell rim is set up with all new chain hardware (iirc), if youre interested in that one.
Looks like the 3 bearing wheel uses 3 of these bearings.
6206-2RS, 62 x 30 x 16 mm
And the two bearing uses this:
Rear wheel 6006.2RSR (55 OD, 30 ID, 13 W)
That said on a 3 bearing the bearing pocket OD should measure 62mm vs 55mm. Also, since the 3 bearing uses 2 on one side and 1 on the other, the pocket depth should be different on either side of a 3 bearing (16mm on one side, 32mm on the other), whereas the 2 bearing should have the same size depth on both sides (13mm).
I found this info from one of Phelans posts on another site, and I put my faith in that guys Buell and Harley knowledge.
Is the rear wheel a 17" ? I didn't know 16.5 rears were ever produced. If it's 17" I want it!
both the marc set and new pirahna just sold. ill update the listing when i get to a computer. i do have a few used buell black rears lying around if anyone is interested in a cheaper spare....or two
Wanted to check if you still have the front rotor and hardware foe sale tks
pm sent for the footpegs
SGS and fazu - PM's sent
Belt G0500.02A8R (used) - $70
Belt G0500.02A8E (used) - $70
XB Coil/wires - $25
XB primary cover (magnesium early version/ramp broken) - $60
XB front rotor with mounting hardware - $70
CRG brake lever (New, full length - AN531) - $65
XB12 exhaust actuator $10
XB VR - $45
XB right side controls $40 (clip on, master cylindar, contrlols, etc. - grip is beat up, but doesn't appear that the clip on was down/rashed)
XB 2004+ filter base and swiss cheesed cover - $20
XB LONG BIKE LH seat rail/BLACK - NEW - $90
XB LONG BIKE LH seat rail/SILVER - NEW - $90
XB ULY seat rail pair - $170
XBS Pegs NEW IN BOX - $35
XB Fuel Rail and injectors - $40
XB9 - Crank/rods - $75
1125 NEW CRG shorty's Brake and Clutch (AN521/AN682) - $120
1125 solenoid - $10
Rear Tail Light (OE) -$10
Rear Tail Light (LED) - $45 (see pics - maybe an xblights? housing is cracked in one section where lens meets base)
XB Race Muffler and 08/09 EBR ECM for race muffler - $425
Last edited by Mope; 08-07-2017 at 08:54 PM.