Results 1 to 5 of 5

Thread: 01 Blast primary bearing help

  1. #1
    Junior Member
    Join Date
    Mar 2017
    Posts
    4

    01 Blast primary bearing help

    Hello, I took of my primary cover a year ago to change my shoe and tensioner guide. I have the manual but after i put everything back together I have 2 small steel bearing left over. they are about a half in long and maybe a 1/4 in diameter. I think they may go somewhere on the clutch shaft. Can anyone help me?

    Also I put it back together without them and started it up there was definitely a ping or rocky noise so i think they are needed somewhere.

    any ideas, and thanks in advance

  2. #2
    Senior Member
    Join Date
    Aug 2009
    Posts
    609
    Are they the locating dowels the go in the case to locate the cover to the case?
    Pic?

  3. #3
    Junior Member
    Join Date
    Mar 2017
    Posts
    4
    It could be, heres a picture tt.jpg

  4. #4
    Junior Member
    Join Date
    Mar 2017
    Posts
    4
    I looked it up, and i believe you are right, do you think they are necessary as i have the cover back on. There is a decently loud thumping pinging sound. Do you think it is the tensioner? And do u have any tips on adjusting it at the clutch. Thank you

  5. #5
    Junior Member
    Join Date
    Mar 2017
    Posts
    4
    *It and the clutch



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •