-
Member
Transmission output shaft seal leak
Now that its running, I have a pretty bad oil leak, I'm pretty sure its the output shaft seal. Any tips on changing this?
Last edited by shabazz18; 07-01-2017 at 03:15 PM.
-
-
Senior Member
Originally Posted by
oh9bolt
Nice google search work!
-
Member
Originally Posted by
oh9bolt
Originally Posted by
Chicknstripn
Nice google search work!
Thats an XB though. Does the rear wheel have to be elevated to release belt tension? I don't have a lift or any specialty stuff. Was hoping this could be done with rubber on the ground.
-
-
Whoops sorry I always forget to look at the sub category
-
Member
After cleaning everything and running it a little, it looks like its coming either from the stator wire grommet or crank sensor. Stator cover was changed recently before I got it, but guess it didnt seal up unfortunately.
-
Senior Member
I don't have a rear stand, I use two jackstands I got from sears with my 3 ton floor jack. While it's on the side stand I place one jack stand under the spool. Then I lean it over on that stand and slide the other one under. Kinda hokey but it works.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules