Since all of the electronics are in the air box on my bike. The tail section is empty except for the shock reservoir and electrical connector to the rear lighting. As a result I can remove the tail section in about 4 minutes. I brought it in and fastened it to my work frame and installed the seat.
Photo Jan 13, 1 10 12 PM.jpg
I then placed the rough air box base where it will be going.
Photo Jan 13, 1 10 44 PM.jpg Photo Jan 13, 1 11 21 PM.jpg Photo Jan 13, 1 10 56 PM.jpg
I had to make a few adjustments to the corner heights so the mounting pegs will fit properly in their location on the base.