Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: Firstgear Dual Remote Control Heat-Troller Holder

  1. #21
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    10,877
    I'm with lowkey on this. Good job TPEHAK. I'm an analog guy and I don't have the skill or access to the tools, but I could! For not even that much $$.

    The future is here. 3-d printers are cheap, and getting cheaper.

    https://www.amazon.com/s/ref=s9_acss...d_i=6066126011

    It's better than duct tape and bailing wire

  2. #22
    Senior Member lowkey's Avatar
    Join Date
    Sep 2012
    Location
    Bullhead AZ
    Posts
    745
    But why buy one when you can outsource the part for so little $ and the machines used by these online companies are FAR better than a hobbyist printer. I had them make a auto power window switch and it was 3 pieces with a clear light bar in the center for interior lighting... it cost $8 dollars to my door. The guy who made the file couldn't even make them on his machine that cheap and less quality (he stopped making them for this reason but offered the file for others).
    Last edited by lowkey; 04-09-2018 at 03:10 AM.

  3. #23
    Senior Member lowkey's Avatar
    Join Date
    Sep 2012
    Location
    Bullhead AZ
    Posts
    745
    Also nobody picked up on the ****ty product name "firstgear" I was making a jab at only working in 1st gear?



Page 3 of 3 FirstFirst 123

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •