Reply With QuoteDo you member the 4 track ?Originally Posted by njloco
Because of this is useful, accurate and elegant solution which works very well. This structure does not need multiple custom parts , just one. And this holder cost just a couple dollars for materials.
And you can not just cut flat clamp, it will not work properly, it is going to be CNC milled bracket with a bunch of features.
If I would decide to go without ziptie I would design probably two 3D printed parts to hold the heattroller, but I like the current design better.
Last edited by TPEHAK; 04-07-2018 at 03:48 PM.
Do you member the 4 track ?
i'll go ya one better young pup.
https://www.youtube.com/watch?v=qtRPCCO-3FE
Does that sync to your phone?
not sure Cody but i know if i'm behind the wheel, start the motor and say "Alexa.....play Frank Sinatra" it fires up.
John, stop teasing them about the good old times besides, you couldn't even drive yet when those were out or am I wrong.
Heck my kids were amazed when I showed them a cassette tape and then, Told them that there was a time before the internet!
^^^^^^ hahahaha. I had a 92 vette some yrs ago and it had the factory Delco Bose head unit w a CD player and a cassette deck, and my at the time teenage son asked me if the cassette opening was for an 8 track. I was like.....are you effing serious!!!!!
Let's be serious, how many people are going to make this holder? How many people have access to a 3D printer? Another look at me see what I can do thread by bag of Tea. Well done Earl Grey!!
Not that anyone else is going to have it made but he did offer the file/work for free and getting it made through shapeways.com in a similar black plastic would run $57.33 without any discount codes they offer, not bad...
Posting Permissions