Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: 3 bearing wheel conversion issues

  1. #11
    Junior Member
    Join Date
    Mar 2016
    Posts
    17
    Hey Lunatic. The dealership I bought from helped me figure out that I have had the spacer bushing on the wrong side. BUT the reason I did so was because 1) that's the way it showed up out of the box and 2) it fits snug I a recess on the pulley side but just sits loose on top of the bearing on the disk side. Is this correct?

    IMG_20180512_100204641.jpg
    Attached Images Attached Images
    Last edited by bukwylde87; 05-12-2018 at 04:15 PM.

  2. #12
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    5,095
    Yes. It absolutely fits on the disk side. Take a look at the diagram Lunatic gave you in post #2.

    It also explains why the disk wasn't lined up. Install it that way, but be sure to follow the manuals instructions on how to properly torque the rear axle twice.

  3. #13
    Junior Member
    Join Date
    Mar 2016
    Posts
    17
    I agree it goes on the disk sideand that is why nothing fit correctly but that's not my question. I want to know if the spacer is just supposed to be loose and sit on top of the bearing. I explained my torquing procedure earlier in the thread. Yes I did it twice.

  4. #14
    Senior Member lunaticfringe's Avatar
    Join Date
    Feb 2011
    Location
    AmishLand, PA.
    Posts
    6,934
    I want to know if the spacer is just supposed to be loose and sit on top of the bearing.

    yes



Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •