Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: How and where should the clutch pull be? And system voltage

  1. #11
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    5,775
    34:19: The syringe will work exactly like a vacuum pump I like the pump because I can create a vacuum and have both my hands free to fiddle with stuff.

    I have a PHX reverse bleeder but haven't used it in a long time. It's really good if your starting with a brand new or totally dry MC, but once I figured out to loosen it up and move the MC around it was easier to do that

  2. #12
    Senior Member pdksh's Avatar
    Join Date
    Nov 2016
    Location
    Ontario
    Posts
    138
    I had to bleed the hydraulic clutch of a 2000ish Honda civic after I accidentally broke a line. The whole system is pretty level so you don't get a good gravity fluid flow. I was about to go INSANE... I even replaced the slave cylinder. After what felt like hours the system finally started to build pressure. Close bleeder, pump, pump, pump, hold, open bleeder did eventually work. I tried a suction tool. I just got my hands on a HUGE syringe. Next time I'll try pressure filling the system from the bleeder nipple. - OH this is the buell thread - sorry. AND AN OLD POST....

    TOO MUCH COFFEE



Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •