I am quite far from mechanically savvy. I know how to check the breaks, tires, and do oil changes. Thats it.
Got a new funnel from canadian tire with some nice measurements on the can and a release valve too!

Oil change went without a hitch until I went to add oil to the rear swing arm.

Only problem is the rubber end on the hose went in the hole but didn't come out.

Now the rubber end is somewhere inside my rear swing arm reservoir and I have no idea how to solve this. The OD of the rubber tip must have been almost exactly the same as the ID of the hole. It is fairly strong thick rubber. I've tried to feel inside to see if its accessible but ive had no luck, its dropped down inside somewhere...

This bike is my main source of commute.

My only solution in mind is a replacement swing arm. I found em online for 50 bucks but its a pretty big job! I definitely do not have the means to do it on my own being in an apartment and not having a centre jack.

Any suggestions or solutions from you wizards out there?

Thanks for taking the time to read this. Cheers.