-
Senior Member
Upper Handle Bar Clamp bolts -- thread/pitch size?
I'm considering this ball mount that takes place of an existing bolt in the upper handle bar clamp: https://www.amazon.com/Mount-Motorcy...70_&dpSrc=srch
It is an M8 pitch diameter (1.25mm) that comes w/ 3 different screws: 25, 30, 35 m
I believe our bikes use these bolts in SAE... 5/16"-18? This link on SPHD seems to be it, but the description says that on XBs it's for rear iso bolts, swingarm bolts, not exactly handlebar clamp screws: https://st-paul-harley-davidson-buel...rear-mount-b4h
Any thoughts?
EDIT: there is also an option to get just the ball and provide your own bolt... any recommendations for the bolt size? I figure I may be able to take it to a hardware store and get something a little bit longer w/ same grade and pitch: https://www.rammount.com/part/RAM-B-367BU
Last edited by AC_Schnitzel; 08-09-2018 at 03:01 PM.
-
The stock bolt size is 5/16"-18 and it is 1" long, I would get the mount then go to the hardware store and size out the proper bolt length.
Last edited by oh9bolt; 08-09-2018 at 03:55 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules