-
Junior Member
buell xb12 fail Code 5 HELP
Are there any people who can see if my tps sensor is done since it's jumping a bit. And see if any other thing is wrong when this code 5 comes from time to time?
has a problem with even gas where it does not run well
are there some here that are good at ecmspy have a small problem with my buel check video in this link please
https://www.youtube.com/watch?v=jlvDcQcsZ9k
Last edited by lennoe; 09-19-2018 at 04:26 PM.
-
Inactive
again......reads like the handiwork BS of our beloved CHICAGO. since i'm sitting in the a/c with 3 minutes to spare i'll give this its due diligence and attention which ain't much:
1-your big, bright, brilliant, cherry-red 5 is the exact moment that the coil is firing.....nothing more. see ECMSPY manual page 22
2-i won't "see" if your TPS unit is bad but YOU can SEE if it's bad by scrolling thru the below:
click my board name.....then click on "find latest posts" below my avatar. scroll till you find my post on OHM TESTING A TPS UNIT. it's all there.
-
Very good job Lunatic You git this covered. It's HOT here in Nashville!!!!
-
Senior Member
Nashville, you rode to Nashville ?
-
-
Senior Member
What is that a picture of ?
-
It's about 30 feet across. I'm actually standing on the center and looking down
-
Senior Member
Thirty feet across but what is it ?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules