I'll try that John. Except I'll be smoking a fresh Pappy Van Winkle and wearing my bright red MAGA shirt. Merry Christmas America.
I'll try that John. Except I'll be smoking a fresh Pappy Van Winkle and wearing my bright red MAGA shirt. Merry Christmas America.
They both work well but some people say buelltooth is more user friendly.They are both effective. Remember buelltooth is for Android any Android phone or tablet with Bluetooth and ecmspy you need laptop. Bottom line they both work. You really don't need either to do a TPS reset on your bike. Like I said it is done by using your throttle on 08 and up bikes.
Last edited by rchuff; 12-26-2018 at 11:22 AM.
Thank you, I appreciate the feedback
So basically i did run another self diagnostics and found some error codes
11
13
15
33
44
45
34
37
Following this DDFI CODES
DDFI Trouble Codes
Code No. Fault Condition
11 Throttle position sensor
13 Oxygen sensor
14 Engine temperature sensor
15 Intake air temperature sensor
16 Battery voltage
21 inter active muffler control
23 Front fuel injector
24 Front ignition coil
25 Rear ignition coil
26,27 clutch and neutral switch
32 Rear fuel injector
33 Fuel pump
34 iac
35 Tachometer
36 fan voltage
37,43 speed sensor
44 Bank angle sensor
45 side stand sensor
46 start relay
47 aux power outlets
52, 53, 54, 55 ECM failure
56 Cam sync failure
Previous issues history with bike.
1. Had fuel pump issues, so i had to buy a complete fuel pump, i could get the pump for 2009 xb9sx so i got the 2004 instead.. More information https://www.buellxb.com/forum/showth...b9sx-fuel-pump
2. I had the bike parked for more than 6months because i could not get a good mechanic to work on the bike here in Nigeria, Thank God i found this Amazing Forum. The bike was parked is a wet area so i believe the water damaged the sensor.
But apart from bad idle when the bike is cold and a backfire sound i keep getting, couple with some funny sound from airbox when reving, The bike starts and run quite okay.
What could be possibly wrong, and why getting so many errors.
Thanks
In a wet area ? Covered, not covered ? If not covered, I agree with SR above ^^^^^^^^^^^^^^^^^^^^^ !
If you are determined to keep it, start by replacing all fuses, electrical contacts in fuse box,sensors, checking all wires and plugs, including ECM, cleaning them, this is a lot of work and very time consuming, I hope you got this bike for free !
Also, see my first response, this is why one should include all info about the bike in the first place.
Last edited by njloco; 12-26-2018 at 02:16 PM.