Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: ECM failure? Also anyone in NJ area want to help out with a spare?

  1. #11
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    6,990
    -Is the wiring good?
    Check CPS signal at the ECM pin, not the sensor. That will confirm good wiring from the sensor and a good signal to the ECM
    -Is the coil and wiring good?
    Trigger the coil from the ECM output pin.
    If no spark: Trigger it at the coil.
    If still no spark: Remove it and triple check the ground contact, still no? Buy a coil.
    If the coil does fire from the ECM pin. Buy an ECM.

    All '03-'07 DDFI-2 ECM's are interchangeable (the XB12 have a center terminal for the IEV not used on a 9). Buy a new one from IDS or SPHDonline that will come with the correct program. Firmware version won't matter.
    OR
    Buy a used unit and download the correct Firmware matching program yourself. IMO I use a wireless bluetooth dongle to my Android phone using ECMDroid. I got all of it ($45 dongle, FREE ECMDroid, and FREE ECM program) from Buelltooth.com

    IMO I think ECMDroid is the easiest tool to use for diagnosis as well. Go to "live data" to check CPS output (it's read at the ECM so you will know the wirings ok) and test the coil (no spark would tell you bad wiring to the coil or bad coil).

  2. #12
    Senior Member
    Join Date
    Mar 2015
    Posts
    1,314
    Check the coil primary connection. Since you had the motor apart, you may not have connected the coil primary (12v connection) plug all the way, and now its disconnected. When I replaced the intake seals on my SS, I didnt have mine connected all the way (connector was cracked) and it was running pretty flaky. It can be hard to see and get to with the engine in place.



Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •