Hi fellows I hope all is well. This is my 1st post so please be easy on me. My stator started going bad a couple weeks ago so I parked it and did the the stator tests. It was putting out 80v a.c. at 4k rpm's. Not grounded out. Tested the plug ends and they showed 0 ohms with a cheap meter. I know its suppose to register 0.1 - 0.3. I purchased a new stator just in case yesterday and so I'm waiting for it to come in. When I took it apart today I found that the coils looks like new but the magnets (all 5) inside the sprocket came loose and were end to end but are not damaged. Could those magnets be giving a false ac reading? I was wanting advice on what glue to use or should I get a new sprocket with the magnets already attached. Would prefer to use some type of glue to save money if possible. Hope I've explained myself well and any replies will be welcomed and respected.