Results 1 to 10 of 10

Thread: Dae

  1. #1
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657

    Dae

    Can't wait to see how this works.
    Attached Images Attached Images
    Last edited by outthere; 04-28-2019 at 08:00 PM.

  2. #2
    Senior Member
    Join Date
    Mar 2019
    Posts
    135
    Nice Welds! Can't wait to see it in place.

  3. #3
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657
    This will end up being my Thunderhill exhaust unless it's quiet. Do they come bare?

  4. #4
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657
    shipped today.

  5. #5
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657
    Does the exhaust hangar look right? He sent a spacer with it but it's not being used.
    Attached Images Attached Images

  6. #6
    Senior Member
    Join Date
    Mar 2015
    Location
    California
    Posts
    418
    Looks right, but make sure you don't overtighten the T-Clamp. I had breakages due to my mistake of overtightening the clamp. I believe he recommends 110-120 in/lbs on those t-clamps.
    Last edited by ocgreenmachine; 05-22-2019 at 12:15 AM.

  7. #7
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657
    Thanks for that I'll double check .

  8. #8
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657
    Deans exhaust performed well at Thunderhill East. Quick to rev off the bottom if not a bit flat up top (The Drummer will bounce the limiter if you let it). Could be a tuning issue. This will be my pipe of choice for Sonoma.

  9. #9
    Senior Member d_adams's Avatar
    Join Date
    Apr 2010
    Location
    Just outside of St. Louis
    Posts
    3,542
    This is the factory torque spec.

    Also, the spacer included depends on how it's mounted. Some require it, others don't. It's dependant on the header mounting and how it's lined up. Most of the time the spacer is used.

  10. #10
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657
    I'm using the spacer



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •