Results 1 to 3 of 3

Thread: Discovered my Machine has el crappo after-market mirrors, signals...

  1. #1
    Junior Member
    Join Date
    Jun 2019
    Posts
    15

    Discovered my Machine has el crappo after-market mirrors, signals...

    ..looking for quality lo-fairing-mount turn signals. anyone have a source for good ones, 28 mm mounting holes ? Already picked the bar end mirrors. If I had the six-hundred bucks, I'd buy the real ones.

  2. #2
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    10,866
    Turn signal "mounting holes" over an inch?? WTH are you putting them?
    I put these bar end signals on the sides of the SX and like them a lot. 19mm hole.

    You can get cheap bar end mirrors that work well. The trick is to make sure they are convex and the mount has a detent. The chrome pivots and bolts are always crap so keep it lubed or waxed. IMO I'd rather get fresh new mirrors every couple years than risk whatever $600 mirrors are(?) if I knock it over.

  3. #3
    Junior Member
    Join Date
    Jun 2019
    Posts
    15
    Nah, the hole spacing is 28 mm spacing, between bolts..like to mount some small singal blunkers, in their place, if not, mebbe some blanking plates. I can always use the outboard lights as blinkers, with a trip to the parts house.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •