Results 1 to 3 of 3

Thread: Discovered my Machine has el crappo after-market mirrors, signals...

  1. #1
    Junior Member
    Join Date
    Jun 2019
    Posts
    2

    Discovered my Machine has el crappo after-market mirrors, signals...

    ..looking for quality lo-fairing-mount turn signals. anyone have a source for good ones, 28 mm mounting holes ? Already picked the bar end mirrors. If I had the six-hundred bucks, I'd buy the real ones.

  2. #2
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    6,584
    Turn signal "mounting holes" over an inch?? WTH are you putting them?
    I put these bar end signals on the sides of the SX and like them a lot. 19mm hole.

    You can get cheap bar end mirrors that work well. The trick is to make sure they are convex and the mount has a detent. The chrome pivots and bolts are always crap so keep it lubed or waxed. IMO I'd rather get fresh new mirrors every couple years than risk whatever $600 mirrors are(?) if I knock it over.

  3. #3
    Junior Member
    Join Date
    Jun 2019
    Posts
    2
    Nah, the hole spacing is 28 mm spacing, between bolts..like to mount some small singal blunkers, in their place, if not, mebbe some blanking plates. I can always use the outboard lights as blinkers, with a trip to the parts house.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •