Hi Bueller tech guys,
as I am trying to figure out everything another question arise:
I read somewhere that DDFI III ECM read sensors 30 times/sec (0.033 sec)
So I suppose the ECM output calculation is not intended to give new value each combustions (0.02 sec at even only 6000 RPM), but every 0.xxx sec.
It seems to me that MLV gives to the monitor new values every something less than 0.2 sec, but not always the same.
As far as you know, the times shown by MLV are true time in between of every new calculation or ECM is faster and the BuellTooth - ECMdroid - MLV arrangement is just not fast enough to shows all of them?
I other words can I be sure that injectors and coils are governed exactly as we can see in MLW?
EFIs are not done straight by God, but by men, so maybe we can get the point too...