I have looked at several other posts with this title and doesnt seem to apply to this bike. I am a very experienced tech, but no buell experience. Bike starts fine, idles a little rough and when you nail the gas it bucks and hiccups then clears out intermittently and will run up to redline. Does it all the time, not intermittent. Here is a list of the new parts; Fuel pump, tps, cylinder head temp sensor, o2 sensor, crank sensor, coil, plugs, coil wires, fuel injectors, air temp sensor. All oem parts. ECM spyware installed and tps reset procedure performed 3 times. Intake manifold seals replaced, no sign of air leaks. Ran some additional grounds into the harness. Battery and cables good, no corrosion, cylinder head ground strap clean. Need a direction to move in. on a side note, its the first fuel injected bike i have worked on without a map/barometric pressure sensor. Seems odd it doesnt use one.

any suggestions would be appreciated

thanks

dave