06 Uly: I noticed my fan wasn't coming on while shutting off my hot bike. Pulled out the Buelltooth and sure enough the fan works as it's supposed to with the Buelltooth. I figure it must be a temp sensor located on the rear head. So, I bought a new sensor, made a removal tool, (someone can have it when I'm finished), removed the old sensor and immediately noticed a difference in the connector, (not the 1/2 inch bolt that is the temp sensor, but the connector). Here's a pic:

IMG_3446.jpg

Do you think I can just cut off both connectors and swap the old, "male push-in" connection onto the new sensor harness and replug it in? I really don't want to mess with the connector on the bike side since there's hardly any room to work with.
Also, is this harness wire a single wire or wire strand? At 80 bucks a shot I don't want to do any exploratory surgery.
Thanks