separate problems that should be addressed individually. your blown 10A pump fuse was the result of either a faulty pump motor or chafing internal pump wires. no idea if you carefully checked those wires during your pump service project.
1-you'll need to clear your historical fault codes....specifically #33....before continuing or everything else becomes moot point. read 2.11......read 2.30
2-no need to tear apart the main feed wiring harness from ecm circuitry to actual pump wiring harness. simply perform an "ohms test" with a multi-meter. read 2.44 for circuitry check.
your problem is specifically listed right there. click link below...use the guidelines/schematics i've outlined for you.
http://buellmods.com/content/downloa...ics_manual.pdf