All,

The 2006 Uly service manual states: Front Rotor Installation, align reference dot on the front rotor with the valve stem.

When removing and reinstalling a used rotor where is this dot? Unfortunately i did not mark the rotor before removing, it seems to run good and the overall wheel balance did not really change. Still a little vibration over 75mph, probably wind or the wearing Pirelli MT-60's.

The manual also states to use all new washers, drive bushings and fasteners when installing a rotor. I cleaned up and put the old stuff back on. I will probably get the wheel powdercoated this winter and could use new hardware then. Thoughts on how critical is using new hardware?

thanks,
Dave