Results 1 to 3 of 3

Thread: Knights 2" Lower Foot Pegs - Brake Pedal

  1. #1
    Senior Member pdksh's Avatar
    Join Date
    Nov 2016
    Location
    Ontario
    Posts
    274

    Knights 2" Lower Foot Pegs - Brake Pedal

    This issue is for an 1125cr but the pegs are originally from a firebolt. I installed a set of 2" lower foot pegs on my 1125cr without any issue. I was able to successfully adjust the snifter leaver but my rear brake pedal is way too high to be useful. Yes I regularly use my rear brake so suggesting I stop using it is not acceptable.

    I want to know if anyone else has over come installing lower foot pegs and adjusting the rear brake pedal. The motorcycle has stock rear sets. I am considering making a plate to re-locate the rear master cylinder.

    Any input would be appreciated.

  2. #2
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    7,964
    Can you shorten the adjustment stud? I find it bottoms out in the clevis pivot end before it runs out of threads (and is frankly dangerous and inop at that point). Taking a few threads off the end might be enough.

    And a neat cheat is to thread a nut onto the stud before you cut the threads off. Then un-thread the nut off the stud and it will clean up the end enough to be able to re-thread the clevis back on

    Hope that works out for ya

  3. #3
    Senior Member 34nineteen's Avatar
    Join Date
    Mar 2015
    Posts
    2,009
    I put Ulysses pegs on my 1125cr. There were some issues, but nothing that couldn't be sorted out with some adjustment/shimming. I dont think the Ulysses pegs are a 2" drop.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •