Results 1 to 2 of 2

Thread: Stator compatability

  1. #1
    Junior Member
    Join Date
    Oct 2019
    Location
    Pittsburgh
    Posts
    7

    Stator compatability

    Don't laugh, this is where I'm at with my custom build. At any rate, planing on changing out all of the wiring and electronics to a sportster CAN bus system. As I was working out the wiring diagram for the conversion, I noticed that my XB12 motor uses a 3 wire Stator. I suppose I could go with 2007 to 2013 sportster electronics that uses J1850VPW bus and a 3 wire stator. However, I'm curious if the bolt patterns for the 3 wire stator is the same as the 2 wire?




    oopswhersmybike.jpg

  2. #2
    Senior Member lunaticfringe's Avatar
    Join Date
    Feb 2011
    Location
    AmishLand, PA.
    Posts
    7,553
    Quote Originally Posted by Ruphobia View Post
    Don't laugh, this is where I'm at with my custom build. At any rate, planing on changing out all of the wiring and electronics to a sportster CAN bus system. As I was working out the wiring diagram for the conversion, I noticed that my XB12 motor uses a 3 wire Stator. I suppose I could go with 2007 to 2013 sportster electronics that uses J1850VPW bus and a 3 wire stator. However, I'm curious if the bolt patterns for the 3 wire stator is the same as the 2 wire?




    oopswhersmybike.jpg
    I'm curious if the bolt patterns for the 3 wire stator is the same as the 2 wire?

    YES.
    but interface pre-drilled holes different.

    you're welcome.


    Last edited by lunaticfringe; 02-16-2020 at 12:01 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •