2007 XB12 problem with starting now after removing and cleaning fuses

[glenn wilton]

Hello all. New guy here with a 2007 XB12STT. Worked on cleaning up the grounds and then went after pulling all the fuses and applying dielectric grease to all the terminals after cleanup. Now the key will turn on but won't turn over. It worked perfectly fine before i pulled the fuses. Oh I also disconnected the ECM and did the same thing to it. Key turns on, gauges sweep and fuel pump turns on but nothing when I hit the starter button. Any ideas? Don't have any spyware or cables yet but the code thats coming up now is #44 Bank Angle Sensor. Not sure why that is there other than the bike was on the side stand while i cleaned everything up. Would this code prevent a start? I'm guessing so. And is there anyway to clear a code without the program?

Thanks in advance.