Results 1 to 3 of 3

Thread: Temperature sending unit tool

  1. #1
    Junior Member Keith Turk's Avatar
    Join Date
    Jan 2020
    Posts
    20

    Temperature sending unit tool

    Guys, I've been whittling on my Uly's issue and had to make a special tool to remove the rear cylinder head temperature sending unit.

    It wasn't hard to do... just slice a groove in the side of a cheap 1/2" deep well socket. I'd be happy to give it to anyone in need.

  2. #2
    Senior Member outthere's Avatar
    Join Date
    Jun 2018
    Posts
    657
    My Snap On thanks you.

  3. #3
    Junior Member Keith Turk's Avatar
    Join Date
    Jan 2020
    Posts
    20
    Most my junk is Snap-on, I just couldn't bring myself to tear up a deep well snap on socket... I've got several junk took kits I've bought on the road when I needed hand tools for some crap job... and a junk socket drawer... this one I built was nothing but the finest in Thiwanizee crapolla... but it worked like stink to remove and replace the sender.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •