main engine nut/stator removal

[mike lowary]

There is a locking tool to hold the sprockets, but some have used a 4" brass hinge. However the actual tool is only a little more than the price of a new (real) brass hinge.

I’ve been using the same brass hinge for 3 years. Works perfectly. And it’s cheap!

[34nineteen]

Is it a real brass hinge? Or brass plated? I'm suprised you would admit to using such a pedestrian material on your bike.


Next you'll be calling Polaner All-Fruit, "jelly".

[mike lowary]

Is it a real brass hinge? Or brass plated? I'm suprised you would admit to using such a pedestrian material on your bike.


Next you'll be calling Polaner All-Fruit, "jelly".

Hell its prolly plated. Think it was $10 at the Home Depot. Still works though

[34nineteen]

yeah, mine was too. I assumed it was real when i first found the hinge, but then realized the hinge was magnetic. Oh well, it worked fine, but I cant find it anymore, so I bought the Jims tool. If you want the measurements, let me know and maybe you can find a tool maker to buid you one.

[mike lowary]

I mite know a guy.....

[34nineteen]

I expect no less from you, sir!

I always had the fear of the hinge popping out under load when torquing the engine nut, and the subsequent dentist visit. However, the Jim's tool doesn't inspire any more confidence based on looks. If it wasnt a Jim's tool, I'd be very afraid and probably looking for a hinge.

[Sdrxb12s]

Got any pics of you using it

[mike lowary]

Got any pics of you using it

You asking me?

[34nineteen]

[mike lowary]

Bingo