This is BuellXB.com Not Honda CB. But since we are full service forum to all people, your answer is *22ft/lbs.
*Your answer can only be as good as your question
Hi
I have looked through my owner manual to try an find torque settings for the two bolts on the brake caliper, but couldn't find it. If anyone has got a larger manual or knows the common torque settings for the CB series, then it would be much appreciated.
This is BuellXB.com Not Honda CB. But since we are full service forum to all people, your answer is *22ft/lbs.
*Your answer can only be as good as your question
Last edited by Cooter; 11-20-2020 at 05:49 PM.
I need torque specs for the rear chain sprocket on a 2005 Yamaha YZF600R....
and
the upper and lower fork clamps for a 2002 Suzuki SV650.
I was going to go through all the hard work of typing these questions into google, but why bother when you will do it for free. What a guy!
Hondas...Suzukis....Yamahas....all require the same amount of torque to all fasterners, for all models.
i routinely twist to maximum allowable torquage. No manual or dedicated wrench required.
Dead balls on accurate? Is that what your f*cking telling me John ?!?!?
Duly noted! It's good to have a few places where we can escape and not get caught in that stuff...
Back to biking !!!
That was a close one
Aww shucks, thanks John! That means a lot, coming from such an authority and the first person to welcome me to the world of Buells.i've always had the utmost respect for you. thank you for deleting and much appreciated.
Maybe we can start a bromance to rival that of 34:19 and Cooter.
Then again, maybe not...
Last edited by Endopotential; 11-23-2020 at 01:42 AM.
We'll just have to leave it between me and my good buddy John You jealous yet???