Anyone know where this hose is supposed to be routed? Don't see any obvious area where its supposed to be connected. Since I have had the bike i usually just tuck it on bottom side of the airbox. Thanks fellas.
signal-2021-03-09-142623.jpg
NOT a factory hose. it appears to be common 5/8" or 3/4" automotive "heater" hose. possible some PO installed it when performing a not-very-well-thought-out breather system modification.
breathalyzer ignition lock out?
Thanks fellas. I'll have to trace it and see where it goes. Will report back
I'd bet a crispy Dong that Barrett and oh9bolt are right.
If it leads down behind the rear cylinder to the case, it is just a vent. Since you have an open airbox anyway, I'd cut it short and stick a Toyota axle vent in the end. They are tiny, cheap, and have a little filter with 1/2psi check valve to keep it closed unless it needs to breathe.
Barrett and oh9bolt are correct. YOU are wrong. Manual Shmanual. I know it's free, but who gots time for dat sheet??
Would have taken less time to bend over and look than post about it. LOL's