Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Intake sealing, the final solution

  1. #11
    Used the james with hylomar. Installed coil bracket bolt, not snug but just to hold the alignment then made sure seals were centered an snugged bolts a lil at a time evenly. Flanges are correct front an rear. I didn't mic the manifold

  2. #12
    If anything I'll use sealant on the manifold itself to seal against the o ring if I have to



Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •