Exhaust straps needed.

[dawidmer]

Hello
Does anyone know where I can buy new front and rear exhaust straps for my 07 XB12STT?
I am located on the west coast of Canada.
Or good used ones....
Thanks

[Cooter]

Buell didn't make them. Get good quality "T-bolt hose clamps". They are commonly used for pressure piping for turbos or boat exhaust, things like that. I can't recall the size but it should be stamped on the broken clamp you have. Someone on here smarter than me should know

Heres a sample:
https://www.amazon.com/T-Bolt-Hose-C...node=979131011

[kz6fittycent]

I bought some, and these are the ones I got but I'd go smaller (~6.5"), as the one I got are just a tad too big: https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

[Barrett]

Sir: You can order them from the below websites. Below is factory sizes. Front different size than 2 rears.
Important: Threaded post of front clamp must face left...............threaded post of both rear clamps must face right. Incorrect orientation shortens their life-span.

West Marine Sales Online
Gardner-Westcott
McMaster.com
Amazon and Ebay

Strap dimensions:
Band thickness approx .028 of an inch
Band width approx 3/4"
Front band length category ID is 5-25/32" to 6-3/32"
Rear band length category ID is 7-1/16" to 7-9/16'

[Cooter]

Oh look! "Someone smarter" showed up.

[34nineteen]

and better looking.

[dawidmer]

After a little more searching I found one at Twinns in Holland. Ordered it and it was here in 4 days. Wowser!
Thanks to all who replied.