hmmm, so I read up plenty about doing this. I don't need fancy CNC catch cans and whatnot. First, it runs fine. I'm getting oil blow by/mist on various parts. Pretty minor, accumulates with time - not instant or anything. The filter is mounted in the upright position versus sideways/upside down which would promote oil pooling.

Is the angle of the tubing too much? I saw numerous other set ups where it looked almost identical and no talk of this issue.
Do I need to relocate the filter? Run a leaner meaner set up that basically goes straight down from the front of the engine instead a rear discharge?
I took it all apart and there's some of that milky oil residue. Nothing poured out or anything obscene.

Thoughts?
oil.jpg
DSCN1333.jpg
DSCN1332.jpg
DSCN1334.jpg