Page 2 of 2 FirstFirst 12
Results 11 to 16 of 16

Thread: 2005 fireboltXB12R enige stops running

  1. #11
    Senior Member 34nineteen's Avatar
    Join Date
    Mar 2015
    Location
    Kolache Factory
    Posts
    4,424
    Blah blah blah blah.
    Last edited by 34nineteen; 06-18-2022 at 07:48 PM.

  2. #12
    Senior Member Barrett's Avatar
    Join Date
    Jun 2020
    Location
    AmishLand, PA
    Posts
    847
    Unable to decipher your trouble-shooting or failure-scenario jibberish....but simple to narrow down and resolve with simple answer. When this thing shuts off...is it as though the kill switch has been placed to the OFF position...or does it give the impression of running out of fuel? As in a more gentler shut-down scenario? Answer defines solution which is typically unique to these R models. And the cause was never a failing CPS. Hoping you retained your original.

  3. #13
    Junior Member
    Join Date
    Jan 2021
    Posts
    10
    Ok problem started last summer. I did spray with starter fluid and ran for second. Had more time in Dec and checked fuel pressure it was 41psi. Pulled fuel pump and one of the 3 plastic clips that holds the washer to keep pressure regulator in had broken off so as not holding pressure regulator tight. replaced housing and put fuel pump back in and fuel pressure was 50 psi.Runs great this year till temp gets 85degrees out. When engine dies seems more like out of gas.After it sits (cools off) for about a hr runs great again

  4. #14
    Senior Member 34nineteen's Avatar
    Join Date
    Mar 2015
    Location
    Kolache Factory
    Posts
    4,424
    I give up.

    Fire sale it and put money down on a 2022 motorcycle.

  5. #15
    Junior Member
    Join Date
    Jan 2021
    Posts
    10
    it turns out that the cooling fan is only running once the bike is turned off

  6. #16
    Senior Member Cooter's Avatar
    Join Date
    Dec 2012
    Location
    Crawling up your skirt
    Posts
    10,877
    Again. Unrelated, and something it's been doing the whole time you've owned it.

    Sorry buddy, the honest truth is that you don't even have enough experience to communicate clearly or follow instructions to solve your problem. You're in over your head. Everyone knows it, except you. Even IF you were to get lucky enough and swap in the right part, it will cost you (and me) more time, money, and frustration than it's worth.

    It's time for you to pay a professional mechanic for help to solve your simple issue. Or go to school. It can be a rewarding career.


    Last edited by Cooter; 06-19-2022 at 04:57 PM.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •