Results 1 to 2 of 2

Thread: 2004 kick stand bolt size?

  1. #1
    Junior Member
    Join Date
    May 2022
    Posts
    11

    2004 kick stand bolt size?

    I did a engine swap and put 04 engine in the 07. When I went to put the kick stand back on the bolts don't match. Anyone know the size on a 04 xb9r?

    Also I noticed when I have it jumped to my car battery it barely turns over but when I start the car and jump it then it actually starts. I'm researching batteries but now a little afraid the battery I get might not have enough starting power.
    Last edited by Yar786; 02-04-2023 at 06:07 PM.

  2. #2
    Senior Member Barrett's Avatar
    Join Date
    Jun 2020
    Location
    AmishLand, PA
    Posts
    843
    Factory manual & schematic "pre-recall" show the below attachment bolts to secure sidestand mounting plate to engine case.

    (2)Bolts, 1 1/2" Allen head alloy steel 5/16x18 (black)


    Remove battery....charge @ 6amps for 15 minutes then load test. Doubt it will pass.

    Battery: ETX-14 correct part number. Do NOT purchase "L" model as the terminals are reversed.
    Should be 220CCA's or more.
    Deka or its equivalent house-brands the best. Reasonably priced and typically produce 10% more CCA's than advertised.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •