09 ECM solution or symptom

[Barrett]

would the cam position or crank position throw a code if the ignition was misfiring?

would the cam position or crank position throw a code if the ignition was misfiring?

NO

[redsqwrl]

so little update. I had a surgery to the clutch hand, that and 2 inches of snow got the bike in the shop ill reassemble order a ecm from santa and get to putting screws in dualsport tires.
but.

i ran it the other day, it took 20 minutes to go into skip mode. i switched ecms and it took another 20 minutes even though the bike was thoroughly warm.

i pulled aux, acc, brake horn fuse to eliminate some potential draws im am leaning towards a chaffed wire or coil pack making the ecms get hot. to thr fan part of my original inquiry. the borrowed ecm commands the fan each and everytime i shut off the bike. my oe ecm did it once in 6 runs.

[redsqwrl]

Well hand is healed, I'm sick of riding my sporty powered frankendrz.

Pulled all fuses and am putting them back in one at a time.

Swapped fans and bought new battery. Reassembled the air intake.

It's not screwing up after 20mins of idling