ECM Spy Download

[YJBoomer]

Thanks Buellysses

[96zj]

Thank you!

[Buellysses]

You just need the drivers from FTDI. I'm not hosting those on my server.

FTDI Link

[Hammel13]

I appreciate the help Buellysses. thank you.

[walrus2004]

I extracted the ECM Maps and there is nothing under the folder for Stock 2004 XB. Every other year has a mapping for stock and race, except for the stock 2004 folder is empty???

[GSXdoubleR88ciNINJA]

They are the same 04-07.

[walrus2004]

sweet... thanks! so I can use the stock mapping from an 05 for my 04?

[Stevenc150]

Mapping, yes - just don't try to flash the whole EEPROM. Just enter maps and other settings over to your stock EEPROM manually using the '05 to go by.

[walrus2004]

anyone know of a step-by-step showing me what to do for this? or can someone walk me through it.

All I am doing is replacing my TPS sensor, so I only need to do what is necessary for that. i am a little worried about screwing something up.

[walrus2004]

referring to my last post... this is the process I was wanting. It still sounds a little tricky (below). But is this the only process I need to do when I connect the bike to ECM Spy after installing the new TPS sensor?

11.1 How to perform a TPS reset
(This chapter applies for models with DDFI-2 injections only. Models from 2008 and later are usually
equipped with DDFI-3 and do not require a TPS reset done by a computer any more.)
On the front left of the engine, between the airscoop and the engine, is the idle adjust screw, which
simply adjusts the butterfly in the injector to allow air through for tickover.
• Connect the bike with the computer
• Turn ignition on and set kill switch to the run position
• Turn out this screw until the throttle voltage doesn't decrease any more
• Keep winding the screw two additional turns
• Close the throttle with light clockwise pressure on the throttle grip. The butterfly is fully closed
if it sticks inside the manifold. It's essential, that this is done whith care, as the TPS reset
needs to be done with the butterfly fully closed!
• Click the "Reset TPS ..." button to perform TPS calibration
• Turn idle adjustment cable clockwise until TPS degrees read 5.2 - 5.6 degrees. This setting is
just to make the engine start and needs to be adjusted to correct idle speed with a warm
engine afterwards.
• Run vehicle until engine temperature is at least 140 °C or 285 °F
• Set idle speed to 1050-1150 min -1