that looks awesome! and at a great price too (i ordered one yesterday). what size connectors did you use?
Step One: Remove the electrics from the orig. light.
Step Two: Remove Lens and reflector housing from bike.
Step Three: New Light. Pay attention to the lettering on the new lens, make sure it's right side up. Also, the LED tail light does NOT have a license plate light.
Step Four: Electrics. Remove the pins from the let light's connector or just cut it if you're lazy,
Step Five: Add MALE quick disconnects to the LED side of the wiring.
Step Six: Plug in the wires to their matching colors on the bikes orig. harness.
Step Seven: LED tail light!!!
that looks awesome! and at a great price too (i ordered one yesterday). what size connectors did you use?
Very Nice! Is it as bright as is seems to be, looks a lot brighter than stock. Curious how much was it?
I used the blue ones... well yellow is BIG, Red is small, blue is middle, i think they will fit 14ga wire... I just crimped the connector right on the pins i took out of the 2010 connector.
the light was $57
Looks great and great to be seen!!!
does anybody have a part number for the light?
Thanks
That tail looks Awesome!! Wonder how/if you could integrate turn signals into it..
Nice write up
part# Y0401.7AC TAIL LIGHT LED, W/O LICENSE PLATE LIGHT.
sweet look...
This might be a dumb question, i am curious about the connectors.
Can i get those at any electronic store?
And what do you call those things?
Can i re-use the ones aleady on my bike?
another question, did u order the light from an HD dealer?
i am done with the questions
thanks
yes and they are called quick disconnects.Originally Posted by Miss_Buell
probably not, and yesOriginally Posted by Miss_Buell
:)