Reply With QuoteI agree with Chief, how about a pict of the other side?
i would like to build my own. i see where all the wires go, but can i see the bottom of the broad to see the connections there?
I agree with Chief, how about a pict of the other side?
We need pics of the bottom or a schematic writeup!
Wonderful! Support DIY!
I customed a cable with a FT232 module for my bike. when i ran the ecmspy software, it occured that failed to get firmware version....Why? What's the firmware?
Nice DIY, in for later
Hi guys. Old topic but it's current subject for me during this winter. I've been thinking about making a bluetooth dongle so I wouldn't need to run my ecmspy cable from under the seat to my backpack where I keep my laptop while datalogging.
So is bluetooth a reliable way to connect to bikes ecm? Found some old topic with google where someone was writing that it's very vulnerable to interferences? Can't find that topic any more...
And then I have another question. Will this bluetooth module do the trick with 5V voltage regulator?
http://www.rhydolabz.com/index.php?m...roducts_id=479
Thanks guys!
a bluetooth connection made with high quality parts is more reliable than a cable.
i found this on another forum that i belong to. im wandering if this would work with emcspy?
http://www.1130cc.com/forums/showthread.php?t=248985
http://users.eastlink.ca/~reastwood/...talink%20Cable
That's not how the buell pins out. 1 is tx 2 is grd 3 is rx 4 is 12v
Posting Permissions